Services

Re-meshing built
for sea spray

Every service below is priced per panel and quoted in writing. We work in apartments, so the method matters as much as the mesh.

Request a quote 351 924 360 723

Window flyscreen re-meshing

Coastal flyscreen mesh fails from the edges in. Salt crystals lodge in the weave, the coating breaks down and the panel starts to sag and stain the sill. We strip the old mesh, wash and de-salt the frame, re-square the corners and re-spline with mesh chosen for your exposure.

Charcoal salt-rated fibreglass mesh
PVC-coated aluminium for windy aspects
New spline, clips and corner stakes
Panels labelled by room on refit

From $45 per panel · 48-hour turnaround

Security door re-meshing

A security door with blown mesh is a screen door with a strong frame. We re-mesh grille and woven-mesh doors with 316 marine stainless, bed it in a new pressure retainer with fresh isolation tape, then re-test the lock, hinges and closer so the door still performs as a barrier.

Woven 316 stainless, 0.8mm aperture
Perforated aluminium option for sliders
Galvanic isolation tape throughout
Built to AS 5039 mesh & retainer specs

From $210 per door · on-site or leaf swap

Sliding & stacker screen repairs

Balcony sliders take the worst of it: salt in the track, grit under the rollers and a mid-rail that bows once the mesh loses tension. We re-mesh the panel, replace rollers with stainless equivalents, scrub the track and set the door so it glides with one finger.

Stainless roller and carriage swap
Track descale and dry lubrication
Mid-rail straightening or replacement
New brush seals to stop draughts

From $89 per panel · hardware quoted separately

Pet-resistant & fine-aperture mesh

If a cat uses your screen as a scratching post, standard mesh lasts a season. Heavy 7-strand pet mesh handles claws and leaning dogs. On high floors we also fit fine-aperture mesh that keeps midges and wind-driven grit out without killing the breeze.

7-strand pet mesh, salt-stable coating
Reinforced bottom rail and extra clips
Midge-grade fine aperture available
Half-pet-mesh, half-fly-mesh splits

From $95 per panel

Strata & whole-building programmes

We run buildings floor by floor with one lift booking, one site contact and one invoice. Before we start, every unit gets a panel register listing sizes, mesh type and condition, so the committee can approve a scope without guesswork.

Written per-unit panel register
Volume pricing above 20 panels
Resident notice letters supplied
$20m public liability certificate on file

Quoted per building · staged invoicing available

Annual salt service & tune-up

The cheapest re-mesh is the one you delay by five years. Once a year we flush every screen with fresh water, clear the tracks, lubricate hardware and leave a written condition note flagging any panel heading for trouble.

Fresh-water flush on all panels
Hinges, locks and rollers serviced
Written condition note per screen
Reminder booking, cancel anytime

From $180 per apartment

Mesh, plainly compared

What we recommend by distance from open surf. We will always tell you the cheaper option if it genuinely suits your aspect.

Mesh	Best for	Coastal life	Security rated
Salt-rated fibreglass	Windows 1 km+ from surf	6–8 years	No
PVC-coated aluminium	Windy balconies, upper floors	5–7 years	No
7-strand pet mesh	Cats, dogs, high-traffic doors	7–9 years	No
Perforated aluminium	Sliding security screens	8–10 years	Yes
Woven 316 stainless	Beachfront entries, front doors	12–15 years	Yes

How a job runs

Four steps, no surprises.

1
Measure
We visit, measure every panel, check frames and hardware, then email a fixed per-panel quote.
2
Remove
Panels come out wrapped and labelled. Security doors are done on site or swapped for a temporary leaf.
3
Re-mesh
Stripped, de-salted, re-splined and tensioned at the bench in St Leonards.
4
Refit
Back in the right rooms, tested, cleaned up, warranty issued with the invoice.

Common questions

Tap a question to open the answer.

Nine times out of ten, yes. If the frame is straight and the corners are sound, re-meshing costs a fraction of a new door. We will tell you honestly when a frame has gone and re-meshing would be throwing money away.

No. Most owners let us in for a 20-minute removal, then again for the refit. If you are away, we can arrange access with your building manager or concierge in writing.

All cutting and stripping happens at the workshop. Inside we use drop sheets, hand tools and a vacuum. Common areas are protected and cleaned before we leave.

We supply the scope, mesh specification, insurance certificate and resident notices your committee needs. Owners or the building manager submit the paperwork; we keep our documents current.

Twelve months on workmanship, spline retention and mesh tension, plus the mesh manufacturer's own coastal warranty. Accidental damage and cyclonic wind events are excluded.

Ready for mesh that survives the salt?

Get a fixed quote 351 924 360 723

Re-meshing builtfor sea spray